Bezel for 128×64 OLED display

This is a custom machined BEZEL for commonly -used 0.96″ 128×64 OLED displays, most often used with Arduino – and sometimes in Raspberry Pi – projects. You can only buy them from our eBay shop.

These displays are low cost. However, as they stand they aren’t very professional-looking. And mounting them into an enclosure or panel usually means a messily cut rectangular(ish) hole and four screw holes. The end result works OK but it doesn’t look great.

These bezels make all the difference! They are custom machined from 6mm Perspex/acrylic. The front face is not machined to preserve the nice black glossy finish of the Perspex.

The rear of the bezel is especially machined to accommodate the 0.96″ OLED display to a maximum size of 28mm x 28mm (of the display’s overall PCB). You need to glue the display (using commonly available adhesives) into the bezel and then glue the bezel into the enclosure or panel. The bezel overlap the cut-out by 2mm all round, thus hiding the usual messy cut-out. 4mm of the bezel sits in the cut-out this leaving 2mm standing proud of the enclosure or panel surface.

Overall, the end result is dramatically better in appearance, looks much tidier and more professional. And there are no screw holes!

The bezel is not an injection-moulded part. It has been individually machined out of Perspex/acrylic, so the sides of the bezel have a machined finish and the front is glossy.

Now also available in WHITE

We have recently introduced a WHITE version of this bezel. This is available from our eBay shop.

How and where to buy these bezels

These bezels are designed, manufactured, and stocked only in the UK, and shipped from the UK only. This is NOT a re-sold component from our friends in the far East. You can buy either the black or white bezels only and exclusively from our eBay shop.

These bezels do not include the OLED display, box/enclosure, or adhesives.

Check out the images of this unique bezel